Table of Contents
Advertisement
To adjust the DAC to obtain the desired Tx power level:
1.
Select the required "Band" and "PA Level," and click the "Get" button. The default ramping value
for the selected band and PA Level will be displayed.
2.
Input the Tx ARFCN (see "Calibration Channels" at the end of this section for the input channel),
and press Enter key. NOTE: If the PCS band is being calibrated, the "1900 Band" box must first
be checked.
3.
Under the "RF Mode" heading, check the "Burst Tx" box. The handset will transmit, and the
power meter will display the default Tx power output.
4.
Input an appropriate value for "DAC16", and click "Set". Check that the power meter registers a
change in power level. NOTE: Before setting a new DAC16 value, turn off the transmitter by
clicking "General Off"
PROVISIONAL ISSUE
− 9-10 −
Advertisement
Table of Contents
