Table of Contents
Advertisement
5.2.5
Microphone and hinge holder removal
1.
Lift the microphone insert from its recess on the lower case cover. Using a Trident screwdriver, remove the single screw
securing the hinge holder. Retain the screw for reassembly. Gently lift up and remove the hinge holder. Retain for reassembly.
5.2.6.
Upper Case Assembly, Flex Board and Display Removal
1.
Gently pull on the left-hand side of the case to remove hinge from lower cover.
Caution: Take care not to damage the flex during disassembly.
2.
Using a strip of plastic (of credit card thickness) gently lift up and remove the logo panel. Remove the two screw caps. Use
a Trident screwdriver to remove the four screws securing the logo panel. Retain the screws for reassembly.
Note: A magnet is located under the logo panel. If when removing the logo panel the magnet separates from the upper
cover, place back into the recessed area in the upper cover. If necessary, replace magnet with new adhesive.
Note: The logo panel and the two screw caps must be replaced with new parts for reassembly.
PROVISIONAL ISSUE
− 5-6 −
Advertisement
Table of Contents
