Table of Contents
Advertisement
5.3.9
Reassembly of the Main PCB Assembly and SD PCB
To be advised.
5.3.10 SD PCB Reassembly
1.
SD PCB assembly includes the following: SD flex connector, vibrator unit, SD PCB, chassis.
5.3.11 Main PCB Reassembly
1.
Main PCB reassembly includes the following: main PCB, all soldered components, four shield covers, dome sheet and PCB
ID label.
2.
Carefully open the ZIF connector by rotating the black locking bar up. Orient the main PCB assembly with the dome sheet
facing up and the ZIF connector in the upper right corner. Orient the SD PCB assembly with the SD PCB on top and the
SD flex connector facing left. Insert the flex into the ZIF connector, aligned in the top and bottom slots and place as far into
the connector as possible. Lock the SD flex connector.
Caution: Use care to open and close the ZIF connector. Damage to or loss of the locking bar will require replacement
of the complete Main PCB assembly.
PROVISIONAL ISSUE
− 5-16 −
Advertisement
Table of Contents
