Table of Contents
Advertisement
3.
Carefully rotate the SD PCB assembly to the opposite side of the main PCB and align the three tabs. Take care not to damage
the SD flex during this step. Press the SD PCB assembly and the main PCB together. Make sure that the two locking hooks
properly engage.
5.3.12 Completing the Assembly
1.
Place the memo button in the slot on the lower cover. Align the keypad and place in the lower cover. Use tweezers to
remove the adhesive liner.
2.
Place the upper housing into the lower cover assembly. Connect the 80 pin connector halves by using the thumb and
forefingers to apply force to the exterior areas directly over the connector. A snap should be heard or felt to insure a secure
connection.
Note: The keypad assembly will be fastened to the main PCB. If this process needs to be repeated due to poor alignment,
the keypad assembly must be carefully removed from the main PCB. A new keypad assembly must be used if the adhesive
is damaged or missing.
PROVISIONAL ISSUE
− 5-17 −
Advertisement
Table of Contents
