Table of Contents
Advertisement
2.
Locate the four screws and torque to 1.3 KGF-CM using a #3ULR0 Trident screwdriver tip.
Note: Several parts come with protective sheets. Do not remove. Take care not to let the tabs of a protective sheet get
trapped between pieces. Do not let the tabs become attached to any adhesive.
5.3.5
Main LCD and Logo Panel Reassembly
1.
Remove the main LCD panel from the liner sheet, and inspect for foreign objects or fingerprints on the interior surface. If
necessary, clean the main LCD glass surface and the interior of the main LCD panel with an ionized air spray. Align the panel
to the correct orientation, and place in the upper cover, starting as close to the top (scalloped) edge as possible. Press
and hold the adhesive areas (around the perimeter) with moderate (not excessive) force to the upper cover for ten seconds.
2.
Place the logo panel in the recess as shown. Ensure that the logo panel is seated correctly. Press and hold the adhesive
areas (at each end) with moderate (not excessive) force to the upper cover for ten seconds
PROVISIONAL ISSUE
− 5-13 −
Advertisement
Table of Contents
