Table of Contents
Advertisement
Notice
The setting (activation/deactivation) of the auxiliary display will be saved (de-
pending on the Infotainment type) in the active user account personalisation
» page
49.
Malfunctions and information messages
Read and observe
on page 240 first.
If the system is not available, an appropriate message appears in the display of
the instrument cluster.
Sensor dirty/covered
If a note appears in relation to the cleaning of the windscreen, clean the wind-
screen or remove the obstruction from the sensor area.
System fault
If an error message appears, seek assistance from a specialist garage.
System limitation
The system displays a message about system limitation in the following cases.
▶
The map documents are not up to date.
▶
The vehicle is located in an area for which no map documents are present.
Fatigue detection system
The fatigue detection system (hereinafter simply the system) advises the driv-
er to take a break from driving when driver fatigue can be detected based on
the driver's steering behaviour.
The system evaluates the steering behaviour at speeds of 60-200 km/h.
Conditions under which a break from driving is detected by the system
▶
The vehicle is stopped and the ignition switched off.
The vehicle is stopped, the seat belt removed and the driver's door opened.
▶
The vehicle is stopped for more than 15 minutes.
▶
If none of these conditions are met or if the driving style is not changed, the
system recommends a driving break again after 15 minutes.
The system can be activated/deactivated in Infotainment in the menu
→ → Driver assistance menu.
242
Driving
Pause recommendation
The icon appears and the following message for a few seconds in the display
of the instrument cluster and a message about detected fatigue. An audible
signal is also emitted.
WARNING
Please take note of the general points relating to the use of assistance
■
systems
» page 206,
For the driving ability is always the driver's responsibility. Never drive if
■
you feel tired.
The system may not detect all cases where a break is needed.
■
Therefore, take regular, sufficient breaks during long trips.
■
There will be no system warning during the so-called micro-sleep.
■
Notice
In some situations, the system can evaluate the steering behaviour incorrect-
■
ly and therefore falsely display a break recommendation.
The system is designed primarily for use on motorways.
■
Tyre pressure monitoring
Introduction
The tyre pressure monitoring function (following known as system) monitors
the tyre pressure while driving.
If the tyre inflation pressure changes, the warning light
strument cluster and an audible signal sounds
The system can only function properly if the tyres have the prescribed inflation
pressure and these pressure values are stored in the system.
Always save the tyre pressure values in the system if one of the following
events occurs.
Change of tyre pressure values.
▶
▶
Change one or more wheels.
▶
Change in position of a wheel on the vehicle.
/
▶
The warning light in the instrument cluster.
in chapter Introduction.
» page
37.
illuminates in the in-
Advertisement
Table of Contents
