Samson 3730-2 Mounting And Operating Instructions page 92

Code list
Code Parameter – Readings/
no. values [default setting]
31* Position transmitter test
–10.0 to 110.0 % of the
operating range, [default
value is last indicated val-
ue of the position transmit-
ter], ESC
Analog position transmitter: Code 29/30/31 can only be selected if the position transmitter (optional) is installed.
3)
32* Error message in case of
'Function check' con-
densed state
[YES], No, ESC
33* Error message in case of
condensed state 'Mainte-
nance required'
[YES], No, ESC
34* Closing direction
CL, [CCL], ESC
35* Blocking position
[0.0] mm/° /%, ESC
92
Description
Testing the position transmitter. Values can be entered in relation to
3)
the operating range.
The momentary valve position is used in initialized positioners locally
as the start value (bumpless changeover to the test mode). When
testing by software, the entered simulation value is issued as the po-
sition feedback signal for 30 seconds.
YES: Error message also in case of 'Function check' condensed
state
No: 'Function check' condensed state does not cause an error
message to be issued
Note
Regardless of the condensed state, the fault alarm output always
switches when the error codes 57, 58, 60, 62 and 64 to 70, 76 are
issued.
YES: Error message only in case of condensed state
'Maintenance alarm' and 'Maintenance required'
No: Error message only in case of condensed state 'Mainte-
nance alarm'
Note
Regardless of the condensed state, the fault alarm output always
switches when the error codes 57, 58, 60, 62 and 64 to 70, 76 are
issued.
CL: Clockwise
CCL: Counterclockwise
Direction of rotation to reach the valve's CLOSED position (view onto
rotary switch with positioner cover open).
Needs only be entered in SUb initialization mode (Code 6).
Enter the blocking position (distance to CLOSED position)
Only necessary with SUb initialization mode.
EB 8384-2 EN