Confirming Error Messages - Samson 3730-2 Mounting And Operating Instructions

If fault alarms exist, the possible source of
error is displayed in Code 49 onwards. In
this case, Err is displayed.
S
Refer to the code list (section 14) for possible
causes and the recommended action.
Fault alarm output
'Maintenance alarm' as the condensed state
causes the optional fault alarm output to be
switched.
− The 'Function check' condensed state can
also activate the fault alarm output
(Code 32).
− The 'Maintenance required/Maintenance
demanded' condensed state can also ac-
tivate the fault alarm output (Code 33).
8.3.1 Confirming error mes-
sages
Enable configuration:
Note
If no settings are entered within 120 sec-
onds, the enabled configuration function be-
comes invalid.
Turn g Code 3, display: No
Press , Code 3 blinks.
Turn  YES
Press , display:
EB 8384-2 EN
Example:
Error caused by pin position
Confirming error message:
Turn  Select the error code that you
want to confirm.
Press .
The error message is confirmed.
Operation
79