Lorex LHA4100 series Instruction Manual page 121

13 FLIR Client 12 for PC / Mac
5. Use the dropdown next to Daylight Saving Time to select a mode of entry for effective
dates:
• Select Week to choose time changes that are relative to the day of the week (for ex-
ample, on the second Sunday of March).
• Select Date to choose a specific date and time for each time change (for example,
on March 13th at 2:00AM).
6. Select the time difference to use for DST from the dropdown next to Time Offset.
7. Enter the desired Start Time and End Time for Daylight Savings Time. System time
will move forward an hour at the start time, and back an hour at the end time.
8. Click Save.
13.6.22 Configuring NTP
Network Time Protocol (NTP) allows the DVR to sync with an NTP time server to ensure
that system time is always accurate.
Prerequisites:
• The DVR must be connected to a router or switch on your network using the included
Ethernet cable. A constant connection to the Internet is required to use NTP.
To configure NTP:
1. Click Remote Setting in the top-right corner of the window.
2. Under System, click General to open the General tab.
3. Select NTP to show NTP options.
4. Click the switch next to NTP to enable (
5. Select the desired NTP server from the dropdown next to Server Address (we recom-
mend using the default ntp.lorexddns.net).
6. If needed, use the dropdown next to Time Zone to set the correct region.
NOTE
In most cases, the region should already be correct as it was configured during the DVR setup wiz-
ard. The selected region is also used by the system to intelligently determine the correct video format
for that region, which may change automatically when changing the region. For example, changing
the region from New York to London will also switch the video format of the system from NTSC to
PAL.
7. Click Save to sync with the NTP.
#LX400086; r. 1.0/39246/39246; en-US
) or disable ( ) NTP on the system.
117