Show Controllers Lre Profile - Cisco Catalyst 2950 Command Reference Manual

Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands

show controllers lre profile

Use the show controllers lre profile privileged EXEC command to display information about the
Long-Reach Ethernet (LRE) profiles and sequences available on the switch.
This command is available only on Catalyst 2950 LRE switches.
Syntax Description
details
names
| begin
| exclude
| include
expression
Command Modes
Privileged EXEC
Command History Release
12.1(11)YJ
Usage Guidelines
Use the show controllers lre profile details privileged EXEC command to see the profiles and
sequences running on each port. This command also shows global profiles and sequences.
For information about LRE profiles supported on your switch and about LRE links, see the "LRE
Profiles" section in the "Configuring LRE" chapter of the switch software configuration guide for this
release.
Use the information in the software configuration guide only as a guideline. Factors such as the type of
Note
cable that you use, how it is bundled, and the interference and noise on the LRE link can affect the actual
LRE link performance. Contact Cisco Systems for information about limitations and optimization of
LRE link performance. The net data rates are slightly less than the gross data rates displayed by the show
controllers lre profile names command output.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
0L-10102-01
show controllers lre profile {details | names} [ | {begin | exclude | include} expression]
Display information about the LRE profiles and sequences available on the switch.
Display information about the Long-Reach Ethernet (LRE) profiles available on the
switch.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Catalyst 2950 and Catalyst 2955 Switch Command Reference
show controllers lre profile
2-309