Rate Selection - Cisco Catalyst 2950 Command Reference Manual

Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands

rate selection

Use the rate selection interface configuration command to enable rate selection on a port. Use the no
form of this command to disable rate selection on the port.
This command is available only on Catalyst 2950 Long-Reach Ethernet (LRE) switches.
Syntax Description This command has no arguments or keywords.
Defaults Rate selection is enabled on all interfaces.
Command Modes Interface configuration
Command History Release
12.1(11)YJ
Usage Guidelines Use the rate selection interface configuration command to enable rate selection on a port. This
command does not start rate selection. To start rate selection, assign a sequence to a port by using the
rate selection sequence interface configuration command or the lre rate selection sequence global
configuration command.
If a global sequence is configured and rate selection is disabled on a port, rate selection runs on all switch
ports except the port on which rate selection is disabled.
Examples
This example disables the rate selection feature on a port:
Switch(config-if)# no rate selection
Related Commands Command
rate selection sequence
lre rate selection sequence
OL-10102-01
rate selection
no rate selection
Modification
This command was introduced.
Description
Assigns a sequence on a port.
Assigns a sequence for the entire switch.
Catalyst 2950 and Catalyst 2955 Switch Command Reference
rate selection
2-251