Cisco Catalyst 2950 Command Reference Manual page 514

speed
Switch(config)# interface fastethernet0/1
Switch(config-if)# speed auto 10 100
You can verify your settings by entering the show interfaces transceiver properties or the
show running-config privileged EXEC command.
Related Commands Command
cpe speed
duplex
show controllers lre
status
show interfaces
show running-config
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-486
Description
Sets the speed of a CPE port.
Specifies the duplex mode of operation for switch ports.
Display the status for rate selection. Use the sequence keyword to display the
status of a sequence for an LRE interface.
Displays the administrative and operational status of all interfaces or a
specified interface.
Displays the current operating configuration. For syntax information, select
Cisco IOS Configuration Fundamentals Command Reference for
Release 12.1 > Cisco IOS File Management Commands > Configuration
File Commands.
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
0L-10102-01