Show Mac Access-Group - Cisco Catalyst 2950 Command Reference Manual

Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands

show mac access-group

Use the show mac access-group user EXEC command to display the MAC access control lists (ACLs)
configured for an interface or a switch.
This command is available only if your switch is running the enhanced software image (EI).
Syntax Description
interface interface-id
| begin
| exclude
| include
expression
Command Modes User EXEC
Command History Release
12.1(6)EA2
Usage Guidelines Use the show mac access-group command without keywords to display MAC ACLs for all interfaces.
Use this command with the interface keyword to display ACLs for a specific interface.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples
This is an example of output from the show mac access-group command:
Switch> show mac access-group
Interface FastEthernet0/1:
Inbound access-list is not set
Interface FastEthernet0/2:
Inbound access-list is not set
Interface FastEthernet0/3:
Inbound access-list is not set
Interface FastEthernet0/4:
Inbound access-list is not set
...
Interface FastEthernet0/47:
Inbound access-list is not set
Interface FastEthernet0/48:
Inbound access-list is not set
Interface GigabitEthernet0/1:
Inbound access-list is not set
Interface GigabitEthernet0/2:
0L-10102-01
show mac access-group [interface interface-id] [ | {begin | exclude | include} expression]
(Optional) Display the ACLs configured on a specific interface (only
available in privileged EXEC mode).
(Optional) Display begins with the line that matches the specified
expression.
(Optional) Display excludes lines that match the specified expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Catalyst 2950 and Catalyst 2955 Switch Command Reference
show mac access-group
2-367