Cisco Catalyst 2950 Command Reference Manual page 372

Hide thumbs Also See for Catalyst 2950:
Table of Contents

Advertisement

show interfaces
Hardware is Ethernet over LRE, address is 0006.2871.5902 (bia 0006.2871.5902)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
Encapsulation ARPA, loopback not set
Keepalive not set
Half-duplex, Auto Speed (10), 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:21, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
This is an example of output from the show interfaces command for all interfaces on a CPE device:
Switch# show interfaces longreachethernet0/2 cpe
Port
----
1
2
3
4
5
Switch#
This is an example of output from the show interfaces command for a port on a CPE device:
Switch# show interfaces longreachethernet0/2 cpe port 5
Port
----
5
Switch#
This is an example of output from the show interfaces media command on an interface:
Switch# show interfaces gigabitethernet0/1 media
Port
Gi0/1
Switch#
This is an example of output from the show interfaces media command:
Switch# show interfaces media
Port
Gi0/1
Gi0/2
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-344
reliability 255/255, txload 1/255, rxload 1/255
8272 packets input, 852898 bytes, 0 no buffer
Received 1182 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 1182 multicast
0 input packets with dribble condition detected
61899 packets output, 17981033 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Status
Speed
------------
-----
notconnected
auto
notconnected
auto
notconnected
auto
notconnected
auto
connected
100
Status
Speed
------------
-----
connected
100
Media-configured
Active
auto-select
rj45
Media-configured
Active
auto-select
rj45
prefer-sfp
sfp
Chapter 2
Duplex
------
NA
NA
NA
NA
half
Duplex
------
half
Attached
1000BaseSX-10/100/1000BaseTX
Attached
1000BaseSX-10/100/1000BaseTX
1000BaseSX-10/100/1000BaseTX
Catalyst 2950 and 2955 Cisco IOS Commands
0L-10102-01

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 2955

Table of Contents