Device Messages - Paradyne Hotwire 7975 User Manual

Device Messages

7975-A2-GB20-40
The Device Messages in Table 6-1, listed in alphabetical order, can appear in the
messages area at the bottom of the ATI screens.
Table 6-1. Device Messages (1 of 2)
Device Message What Message Indicates
Access level is The operator requested that
Operator. configuration options be
Configuration is loaded, but does not have
read-only. authority to edit them.
Cannot Save – no All of the login IDs being
Login IDs with Access saved have an access level
Administrator below Administrator.
Command Complete Action requested has
successfully completed.
Invalid Character ( x ) A nonprintable ASCII
character ( x ) has been
entered.
Invalid – Data Network-initiated loopback
Terminal Initiated was in progress when
Loopback Active another selection was
made.
Invalid Password Login is required and an
incorrect password was
entered; access is denied.
Invalid – Send Pattern A pattern test was already
Already Active in progress when the Start
field was selected.
Invalid – [ Test ] The described test was
Already Active already in progress when
another selection was
made.
Invalid Test A loopback or pattern test
Combination was in progress when Start
was selected to start
another test, or was active
on the same or another
interface when Start was
selected.
December 1998
Messages and Troubleshooting
What To Do
If configuration options are to be
edited, use a Login ID that has
Administrator authority.
Change the access level of at
least one Login ID to
Administrator so that
configuration changes can be
made. (Operator-level users
cannot make configuration
changes.) Save the Login IDs.
No action needed.
Reenter information using valid
characters.
No action needed.
H
Try again.
H
Contact your system
administrator to verify your
password.
H
Allow test to continue.
H
Select another test.
H
Stop the test.
H
Allow test to continue.
H
Select another test.
H
Stop the test.
H
Wait until other test ends and
message clears.
H
Abort all tests from the Test
menu screen.
H
Stop the test from the same
screen the test was started
from.
6-3