13. Position throttle arm slot to face stop harness exit
hole in tiller handle. Route stop switch harness
through twist grip, into throttle arm, and out
through side of tiller handle.
a
b
c
a - Slot
b - Exit Hole
c - Harness
d - Twist Grip
e - Stop Switch
14. Secure twist grip to throttle arm with attaching
screw.
a - Screw
7B-16 - ATTACHMENTS/CONTROL LINKAGE
e
d
51602
a
51603
15. Sta-strap harness to throttle arm.
CAUTION
Allow enough slack in harness (rotate throttle
grip in both directions) before securing harness
to handle assembly with J-clip.
16. Attach harness to tiller arm with J-clip allowing
enough slack in harness for full throttle rotation.
17. Attach sta-strap to end of harness sleeve.
b
a - Sta-strap
b - J-clip
18. Install rubber twist grip by aligning ridges on plas-
tic twist grip with grooves inside of rubber grip.
NOTE: Applying a soapy water solution to rubber grip
will ease installation.
a - Ridges
b - Grooves (Under Handle)
a
51603
b
a
51603
90-852572R1 JANUARY 1998