Mercury 40 Service Manual page 209

1. Install lifting eye (P/N 91-90455) into flywheel a
minimum of 5 turns. Install powerhead to drive-
shaft housing. Slide shift slide on rail while lower-
ing powerhead on splines of drive shaft.
2. Install Powerhead bolts. Torque to 28 lb.ft.
(38 N·m).
a
a - Bolts
90-852572R1 JANUARY 1998
3. Install cover. Torque bolts to 80 lb. in. (9 N·m).
55320
a - Bolts - Torque to 80 lb. in. (9 N m)
b - Cover
4. Reattach ground wire to powerhead. Connect
a
a - Ground Lead
55319
b
wires from trim relay switch. Connect tell tale
hose.
a
a
55014
POWERHEAD - 4-39