Water Pump Re-Assembly And Installation - Mercury 40 Service Manual

Water Pump Re-assembly and
Installation
1. Place seal on longer shoulder side of tool.
2. Press into water pump base until tool bottoms.
87
Super Duty Gear Lubricant (92-850737A1)
87
a - Seal (Install with spring visible when installed.)
b - Seal Installation Tool (91-817006)
3. Place seal on shorter side of tool.
4. Press into water pump base until tool bottoms.
87
b
Super Duty Gear Lubricant (92-850737A1)
87
a - Seal
b - Shorter Side of Tool
c - Seal Installation Tool (91-817006)
90-852572R1 JANUARY 1998
b
a
55876
c
a
55877
NOTE: If installation tool is not available, press seals
in as shown to depths indicated.
0.04 in. (1.02 mm)
a - Seal (Install with spring visible when installed.)
b - Seal (Install with spring visible when installed.)
c - Seal Bottom
5. Install O-ring. Lubricate O-ring and gear housing
bore with Quicksilver Special Lubricant 101.
6. Install water pump base into gear case.
95 2-4-C w/Teflon (92-850736A1)
a - O-ring
b - Water Pump Base
c - Gear Case
a
b
c
55878
b
a
95
c
55879
LOWER UNIT - 6B-29