4. Disconnect link rod from cam lever.
5. Remove tilt lock pin. Remove nuts and washers
securing the lower pivot pin. Remove anode bolt
to remove ground strap. Remove lower anchor
pin. Retain the anchor pin bushings from the
clamp brackets and trim unit.
6. Remove trim unit.
a
f
a - Tilt Lock Pin
b - Link Rod
c - Cam Lever
d - Nut (2)
e - Anode Bolt/Ground Strap
f - Pivot Pin
90-852572R1 JANUARY 1998
b
c
d
e
Manual Trim System
Installation
1. Apply 2-4-C Marine Lubricant to surface of lower
anchor pin and anchor pin hole. Place trim into
proper position. Install anchor pin and bushings
into anchor pin hole and clamp brackets. Install
nuts and washers to anchor pin and tighten se-
curely. Install ground strap and anode bolt.
2. Install tilt lock pin.
a
d
95
2-4-C w/Teflon (92-850736A1)
a - Tilt Lock Pin
b - Nut (2)
c - Anode Bolt/Ground Strap
d - Pivot Pin
95
b
c
MID-SECTION - 5E-5