Banner q4x Instruction Manual page 9

Top Menu
Teach Process Selection
Response Speed
Gain and Sensitivity
Output Timing Delays
Delay Timer
Available when
selected
Available when
selected
Select Zero Reference Location
Shift Zero Reference after Teach
Input Wire Function
Display Read
Exit Setup
Reset to Factory Defaults
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Sub Menus
two-point static BGS
dynamic BGS
one-point Window (FGS)
one-point BGS
set Response Speed to 1.5 ms
set Response Speed to 3 ms
set Response Speed to 10 ms
set Response Speed to 25 ms
set Response Speed to 50 ms
*
high excess gain mode
standard excess gain with increased noise immunity
Gain menu is available when Response Speed is set to 10, 25 or 50 ms
off: no delays enabled
enable on and/or off delay (set value in Delay Timer menu)
1 Shot, fixed output pulse duration
LO = On pulse when a target is detected inside of the switch point(s)
DO = On pulse when a target is detected outside of the switch point(s)
ms to sec range, set Delay Timer value (seconds have decimal)
when is selected,1 to 9 ms is range available when Response Speed is
set to 1.5 or 3 ms
near: set zero displayed value to end of 18 mm barrel
far: set zero displayed value to maximum detection range
on: move the zero point after each teach
off: zero point is either at end of barrel or
maximum detection range
off: remote teach input is not active
set: Remote Teach input
laser off when pulled low
master
slave
display on
display on, inverted
display off (enters sleep mode after 60 seconds)
display off, inverted (enters sleep mode after 60 seconds)
end: select to exit setup
no: do not reset to factory defaults
yes: reset to factory defaults
Figure 9. Sensor Menu Map
Q4X Stainless Steel Laser Sensor
( default setting)