Manual Adjustments; Remote Input - Banner q4x Instruction Manual

Setting
Output timing delays (
Response speed ( )
Shift the Zero Reference Location after a TEACH (
TEACH process selection (
Zero reference location (

3.3 Manual Adjustments

Manually adjust the sensor switch point using the
1. From Run mode, press either
2. Press to move the switch point up or
switch point value flashes rapidly, the new setting is accepted, and the sensor returns to Run mode.
NOTE: When FGS mode is selected (the FGS indicator is on), manual adjustment moves both sides of
the symmetrical threshold window simultaneously, expanding and collapsing the window size. Manual
adjustment does not move the center point of the window.

3.4 Remote Input

Use the remote input to program the sensor remotely. The remote input provides limited programming options and is
Active Low. For Active Low, connect the gray input wire to ground (0 V dc), with a remote switch connected between the
wire and ground. Pulse the remote input according to the diagram and the instructions provided in this manual.
The length of the individual programming pulses is equal to the value T: 0.04 seconds ≤ T ≤ 0.8 seconds.
Exit remote programming modes by setting the remote input low for longer than 2 seconds.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
)
)
)
and
or one time. The current switch point value flashes slowly.
to move the switch point down. After 1 second of inactivity, the new
Factory Default
—No delay
10 ms
) —0 = the end of barrel
—Two-point TEACH
—Measurement increases further from sensor
buttons.
Q4X Stainless Steel Laser Sensor