Zero Reference Location - Banner q4x Instruction Manual

Output
OFF Delay
ON Delay
1-Shot
When either or
set the timer(s):
• —On delay
• —Off delay
• —One-shot delay timer
NOTE: For the one-shot delay timer:
• LO = On pulse when a target is detected inside of the switch point(s)
• DO = On pulse when a target is detected outside of the switch point(s)
Delay Timers
Use these menus to set the delay timers. These menus are available only if an output timing delay is selected.
For and , the default is 0.
For , the default is 10 milliseconds for 10, 25, and 50 millisecond response speeds and 1 millisecond for 1.5 and 3
milliseconds response speeds.
Use and to scroll through the values. Values greater than 10 increase or decrease by increments of 10. Millisecond
values do not include the decimal point; seconds values include the decimal point.
• 1 to 9 ms (when
• 10 to 90 ms
• 100 to 900 ms
• 1.0 to 90.0 s

3.2.4 Zero Reference Location

Use this menu to select the zero reference location. The default is
• —0 = the end of the sensor barrel; the measurement increases further from the sensor
• —0 = maximum range; the measurement increases closer to the sensor
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
D
D
D
Figure 10. Output Timing Delays
is chosen, the sensor returns to the Setup menu and additional options become available to
, ,
is selected, the 1 to 9 ms range is available for 1.5 and 3 ms response times)
D
D
Time
, 0 = the end of the sensor barrel.
Q4X Stainless Steel Laser Sensor
ON
OFF
D
(D = 1 - 9999 ms)