Reset To Factory Defaults Using The Remote Input; Locking And Unlocking The Sensor Buttons; Teach Procedures; Two-Point Static Background Suppression Teach - Banner q4x Instruction Manual

3.4.2 Reset to Factory Defaults Using the Remote Input

Eight-pulse the remote input to apply the factory defaults and return to Run mode.
T T T T T
T T T T
NOTE: The input wire function remains at remote teach input (

3.5 Locking and Unlocking the Sensor Buttons

Use the lock and unlock feature to prevent unauthorized or accidental programming changes. When locked,
displays when the (SELECT)(TEACH) button is pressed. The switch point displays when (+)(LO/DO) or (-)(MODE) are
pressed, but displays if the buttons are pressed and held.
Button Instructions
To lock or unlock the sensor using the buttons, press and hold
depending on the previous status.
Remote Input Instructions
1. Access the remote input.
Action
Four-pulse the remote input.
2. Lock or unlock the sensor buttons.
Action
Single-pulse the remote input to unlock the sensor.
Double-pulse the remote input to lock the sensor.

3.6 TEACH Procedures

Use the following procedures to teach the sensor.
To cancel a TEACH procedure, press TEACH for longer than 2 seconds, or hold the remote input low for longer than 2
seconds. momentarily displays when a TEACH procedure is canceled.

3.6.1 Two-Point Static Background Suppression TEACH

Two-point TEACH sets a single switch point. The sensor sets the switch point between two taught target distances, relative
to the shifted origin location.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
T T T
T T T
).
and press four times.
Result
T T T T The sensor is ready to have the button
T T T state defined and
Result
T
Run mode.
T T
T Run mode.
Q4X Stainless Steel Laser Sensor
or flashes,
displays.
displays and the sensor returns to
displays and the sensor returns to