Sensor Programming; Light Operate/Dark Operate; Setup Mode - Banner q4x Instruction Manual

Stainless steel laser sensor

Hide thumbs Also See for q4x:

Table of Contents

Q4X Stainless Steel Laser Sensor

3 Sensor Programming

Program the sensor using the buttons on the sensor or the remote input (limited programming options).

In addition to programming the sensor, use the remote input to disable the buttons for security, preventing unauthorized

or accidental programming changes. See

The default output configuration is light operate. To switch between light operate and dark operate, use the following

instructions:

1. Press and hold LO/DO for longer than 2 seconds. The current selection displays.

2. Press LO/DO again. The new selection flashes slowly.

3. Press SELECT to change the output configuration and return to Run mode.

NOTE: If neither SELECT nor LO/DO are pressed after step 2, the new selection flashes slowly

for a few seconds, then flashes quickly and the sensor automatically changes the output

configuration and returns to Run mode.

Access Setup mode and the sensor menu from Run mode by pressing and holding MODE for longer than 2 seconds. Use

and

to navigate through the menu. Press SELECT to select a menu option and access the submenus. Use

to navigate through the submenus. Press SELECT to select a submenu option and return to the top menu, or press

and hold SELECT for longer than 2 seconds to select a submenu option and return immediately to Run mode.

To exit Setup mode and return to Run mode, navigate to

Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com

Locking and Unlocking the Sensor Buttons

and press SELECT.

on page 15 for more information.

and

Table of Contents