Installation; Install The Safety Label; Sensor Orientation - Banner q4x Instruction Manual

Q4X Stainless Steel Laser Sensor

2 Installation

2.1 Install the Safety Label

The safety label must be installed on Q4X sensors that are used in the
United States.
NOTE: Position the label on the cable in a location that
has minimal chemical exposure.
1. Remove the protective cover from the adhesive on the label.
2. Wrap the label around the Q4X cable, as shown.
3. Press the two halves of the label together.

2.2 Sensor Orientation

Optimize detection reliability and minimum object separation performance with correct sensor-to-target orientation. To
ensure reliable detection, orient the sensor as shown in relation to the target to be detected.
See the following figures for examples of correct and incorrect sensor-to-target orientation as certain placements may
pose problems for sensing some targets. The Q4X can be used in the less preferred orientation and provide reliable
detection performance; see
Correct
Figure 5. Orientation by a wall
Correct
Figure 7. Orientation for a height difference
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Figure 4. Optimal Orientation of Target to Sensor
Figure 16 on page 23 for the minimum object separation distance required for each case.
Incorrect
Incorrect
COMPLIES WITH 21 CFR 1040.10 AND 1040.11
EXCEPT FOR DEVIATIONS PURSUANT TO
LASER NOTICE No. 50, DATED JUNE 24, 2007.
BANNER ENGINEERING CORP.
9714 10TH AVENUE NORTH
COMPLIES WITH IEC 60825-1:2007
MINNEAPOLIS, MN 55441
Figure 3. Safety Label Installation
Correct
Figure 6. Orientation for a turning object
(Optimal)
Horizontal
Orientation
Figure 8. Orientation for a color or luster difference
CLASS 1
LASER PRODUCT
Incorrect
Vertical
Orientation