Paper Sensor, Paper Overflow Sensor And Tray Exit Sensor - Ricoh B003 Service Manual

4.2.2 PAPER SENSOR, PAPER OVERFLOW SENSOR, AND TRAY
EXIT SENSOR
[A]
NOTE: When removing the paper sensor or paper overflow sensor for the 1st tray,
or the tray exit sensor above the 1st tray, first remove the 1st tray and
remove the sensor cover, then remove these sensors.
1. Remove the tray (see Trays).
2. Remove the sensor cover [A] (3 screws).
Paper Overflow Sensor
3. Remove the grounding wire [B] (1 screw) and paper overflow sensor bracket
[C] (1 screw).
4. Remove the paper overflow sensor [D] (1 connector).
Paper Sensor
5. Remove the paper sensor [E] (1 screw, 1 connector).
Tray Exit Sensor (above the 1st tray, and in the 3rd, 6th, and 9th trays)
6. Remove the tray exit sensor [F] (1 screw, 1 connector).
7. After replacing the tray exit sensor, perform the tray exit sensor adjustment
(see Tray Exit Sensor Adjustment).
NOTE: After replacing the tray exit sensor, do not put the rear cover back on
the mailbox, because the tray exit sensor adjustment must be
performed first.
SM
CÓPIA NÃO CONTROLADA
[B]
[E]
15-23
CÓPIA NÃO CONTROLADA
[C]
[D]
[F]
G909R506.WMF
B003/B004/B006/B007
TRAY UNIT