Fcu - Ricoh B003 Service Manual

Firmware History for B003/B004/B006/B007

FCU:

Version
01.05.00
02.00.04 First page print from
Document Server
Output to G3-1 paper
tray
Transmission result
report
No Confidential File
Report
First Page Print from
Document Server (A5)
Page split with G4
immed. reception.
Destination erased
Memory full
Memory Storage Report
03.00.00 Document from D.
Server comes out blank
SP6-107-001
Large log files printed
out
"Storage" when SAF
memory full
ISDN-G3 transmission
Batch transmission
CÓPIA NÃO CONTROLADA
Title
1st mass production
A) The file name is not printed when an A4 size document is
output to A5 paper.
B) The edge of the document's image area is not printed out in
inch resolution mode.
C) With fine print mode, the first page comes out enlarged if
the expansion option memory has not been installed.
Documents from the Document Server sent in memory
transmission are printed out to the paper tray appropriated for
the G3-1 line.
1. The transmission results report is printed out when the
memory reaches capacity.
2. In cases where the transmission results report cannot be
printed out (e.g. no paper), files cannot be sent following
this.
The confidential file report is not printed out in the following
conditions.
- The line is disconnected during phase C of confidential
reception.
- There are no confidential reception files stored in the
machine.
With the First Page print function, the image shifts to the right
of the center mark when an A5 document from the Document
Server is printed out to A5 paper.
The last page of a G4 immediate reception job is split into 2
pages (top and bottom halves of the image).
If a memory transmission destination is changed and the power
is turned Off/On, the destination is erased. (Only those existing
destinations that have been changed are deleted).
If the SAF memory reaches capacity during scanning, the file is
saved but the filename does not initially appear on the file list
(it is necessary to exit and re-enter the filename display
screen).
If the filename for a Document Server document is 8
characters or longer, it will not appear on the memory storage
report.
If the user initiates a printout of a Document Server document
while the memory transmission results report is being printed
out, the document will come out as a blank page
Some unnecessary (large) log files had been carried over,
causing it to take a very long time to print out all the log files
with this SP mode.
If a document with cover sheet is sent from a PC using the
LAN FAX driver, the machine allows the operation of "storing" a
document, even though the SAF memory is full. (i.e. document
is not actually stored).
The DTMF tone is sent to the ISDN-G3 line after pressing the
tone key, even if user parameter switch 11(0B) is set to 0
(UUI).
When sending with Batch Transmission, the dedicated
transmission parameters are not applied to destinations
entered in with the ten-key pad. (those entered w/Quick Dials
are fine).
CÓPIA NÃO CONTROLADA
Symptom Corrected
Page 10 of 15