Ricoh B003 Service Manual page 937

Rev. 08/2003
5914* Application Counter
Display
5915 Mechanical Counter
Detection
5918* A3/DLT Counter Display
5923* Flame Elimination Area
Change
5958 Feed Clutch Start Timing
Adjustment
5961* Large Capacity Exit Mode
Ÿ
5962 8K 16K Paper Mode
To set the plug and play model name, enter the
model number, and then press
Selects whether or not the total printer counter is
displayed in the UP mode.
0: Off , 1: On
Checks whether the mechanical counter inside
the inner cover is connected or not.
Display:
0: Not detected
1: Detected
2: Unknown
Sets the key press display for the counter key.
[0, 1 / 1 / --]
This setting has no relation to (SSP) SP5-104
A3/DLT Double Count.
Toggles between two settings that affect the
appearance of the pages for border removal and
printed facing pages: (1) Using the original area
as the allotted area, or (2) Using only the copy
paper as the allotted area.
[0, 1/ 0 / --]
0: Original area used as base
1: Copy used as the base
Adjusts the clutch timing to optimize the intervals
between fed sheets to reduce jams in the feed
unit.
[35 ~ 57.5 / 42.5 / 2.5mm]
Selects whether or not all stapled copies are sent
to Shift Tray 1 when the Two-Tray finisher is
installed.
[0, 1 / 1 / ---]
0: Enabled
1: Disabled
Switches on/off the use of 8-kai, and 16-kai China
paper sizes.
[0~1 / 0 / 1]
0: Off. 8-kai, 16-kai paper sizes are not displayed
after pressing the selection key.
1: On. 8-kai, 16-kai paper sizes displayed after
pressing the selection key. For this setting to
take effect, "2" must be selected for SP5131.
With "2" (Europe) selected for SP5131, the ADF
can select 16-kai LEF. With SP5962 set for "0"
(Off), the nearest size is detected as shown
below.
Size Loaded
16-kai SEF
16-kai LEF
8-kai SEF
.
Size Detected
B5 SEF
B5 LEF
B4 LEF