Ricoh B003 Service Manual page 817

Tech Service Bulletin No. B003/B004/B006/B007 – 006
Page 3 of 4
CLEANING ROLLER BRUSH REPLACEMENT PROCEDURE:
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA
1. Remove the Drum. (Refer to 3.11.2
on the service manual)
2. Remove the snap rings [A].
3. Remove the springs [B].
4. Remove the charge roller [C].
5. Remove the spring [D].
6. Remove the E-ring [E]
7. Remove the cover [F].
8. Remove the stud [G].
9. Remove the cleaning pad Ass'y
[H].
10. Remove the bushings [I], front
terminal [J] and rear terminal [K].
11. Install the front terminal [J], rear
terminal [K] and bushing [I] to the
new front [M]and rear arm [L].
12. Install the new front arm [L], the
rear arm [M], the stud [G], the new
brush roller [N] and the charge
roller [C]
13. Install the E-ring [E] and the snap
rings [A].
14. Install the new springs [P].
15.
Put back the cover [F] and the
Drum.
Continued...