Ricoh B003 Service Manual page 671

BIT SWITCHES
System Switch 04
No
⇒
6 G3 CSI/G4 Terminal ID
programming
0: Enabled
1: Disabled
Telephone line type
7
programming
0: Enabled
1: Disabled
System Switch 05 - Not used (Do not change the factory settings.)
System Switch 06
No
Margin setting for Create Margin
0
to Transmission
7
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
System Switch 09
No
0 Addition of image data from
confidential transmissions on the
transmission result report
0: Disabled 1: Enabled
1 Inclusion of communications on
the Journal when no image data
was exchanged.
0: Disabled 1: Enabled
2 Automatic error report printout
0: Disabled 1: Enabled
3 Printing of the error code on the
error report
0: No 1: Yes
4 Not used
5 Power failure report
0: Disabled 1: Enabled
6 Conditions for printing the
protocol dump list
0: Print for all communications
1: Print only when there is a
communication error
7 Priority given to various types of
remote terminal ID when printing
reports
0: RTI > CSI > Dial label > Tel.
number
1: Dial label > Tel. number > RTI
> CSI
B003/B004/B006/B007
CÓPIA NÃO CONTROLADA
FUNCTION
FUNCTION
FUNCTION
CÓPIA NÃO CONTROLADA
COMMENTS
0: The CSI and Terminal ID must be set from:
User Tools – Key Operator Tools – Program ISDN-G3
Line.
Note: The Terminal ID can only be programmed if a
Group 4 option is installed.
0: Telephone line type selection (tone dial or pulse
dial) must be set from:
User Tools – Key Operator Tools – Select Dial/Push
Phone.
COMMENTS
71 to 99 (BCD) %. This setting determines the
reduction ratio when the user uses the Create Margin
Transmission feature.
Default setting:1001 0011 (93%)
COMMENTS
If this feature is enabled, the top half of the first page of
confidential messages will be printed on transmission
result reports.
0: Communications that reached phase C (message
tx/rx) of the T.30 protocol are listed on the Journal.
1: Communications that reached phase A (call setup)
of T.30 protocol are listed on the Journal. This will
include telephone calls.
0: Error reports will not be printed.
1: Error reports will be printed automatically after failed
communications.
1: Error codes are printed on the error reports.
Do not change the setting.
1: A power failure report will be automatically printed
after the power is switched on if a fax message
disappeared from the memory when the power was
turned off last.
This switch becomes effective only when system
switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a protocol
dump list only for communications with errors.
This bit determines which set of priorities the machine
uses when listing remote terminal names on reports.
In G4 communication, G4_TID (Terminal ID) is used
instead of RTI or CSI.
Dial Label: The name stored, by the user, for the
Quick/Speed Dial number.
3-14
Rev. 09/2002
SP No. 1-101-005
SP No. 1-101-007
SP No. 1-101-010
SM