Spacing Of Rack Mounting Bracket Holes For The Srx5600 Services; Gateway; Connection To Building Structure For The Srx5600 Services Gateway - Juniper SRX5600 Hardware Manual

SRX5600 Services Gateway Hardware Guide
Related
Documentation
Spacing of Rack Mounting Bracket Holes for the SRX5600 Services Gateway
Related
Documentation
48
With the use of adapters or approved wing devices to narrow the opening between the
rails, the services gateway can fit into a 600-mm-wide rack, as defined in the four-part
Equipment Engineering (EE); European telecommunications standard for equipment practice
(document numbers ETS 300 119-1 through 119-4) published by the European
Telecommunications Standards Institute (
Observe these guidelines:
The rack must have sufficient vertical usable space to accomodate the height of the
services gateway: 14.0 in. (35.6 cm) high (approximately 8 U). You can stack five
services gateways in a rack that is at least 48 U (89.3 in. or 2.24 m) in height.
NOTE: A U is the standard rack unit defined in Cabinets, Racks, Panels, and
Associated Equipment.
The location of the rack must provide sufficient space to accomodate the depth of the
services gateway. The chassis is 24.5 in. (62.2 cm) deep.
The rack must be strong enough to support the weight of the fully configured device,
up to 163.5 lb (74.2 kg). If you stack five fully configured devices in one rack, it must be
capable of supporting up to 818 lb (371.0 kg).
Overview of Installing the SRX5600 Services Gateway on page 43
Site Preparation Checklist for the SRX5600 Services Gateway on page 45
Spacing of Rack Mounting Bracket Holes for the SRX5600 Services Gateway on page 48
Connection to Building Structure for the SRX5600 Services Gateway Rack on page 49
Clearance Requirements for SRX5600 Services Gateway Airflow and Hardware
Maintenance on page 49
The services gateway can be mounted in any rack that provides holes or hole patterns
spaced at 1 U (1.75 in.) increments. The mounting brackets used to attach the chassis to
a rack are designed to fasten to holes spaced at those distances.
Overview of Installing the SRX5600 Services Gateway on page 43
SRX5600 Services Gateway Rack Size and Strength Requirements on page 47
Connection to Building Structure for the SRX5600 Services Gateway Rack on page 49
Clearance Requirements for SRX5600 Services Gateway Airflow and Hardware
Maintenance on page 49
).
http://www.etsi.org
Copyright © 2010, Juniper Networks, Inc.