Operating The Cue Function - Yamaha CL1 Reference Manual

[CUE] key in the Centralogic section
(when controlling MIX channels or MATRIX channels)
4
Other CUE group
These cue signals are operated via buttons displayed on the touch
screen. This group is enabled if you turn on the CUE button in the
EFFECT popup window or the PREMIUM popup window, or if
you turn on the KEY IN CUE button in the DYNAMICS 1 popup
window. This group will automatically be disabled when you exit
the corresponding popup window.
You cannot turn on cue monitoring between different groups simultaneously. Normally, the
group to which the most recently-pressed [CUE] key (or on-screen CUE/KEY IN CUE button)
belongs will take priority, and the [CUE] keys for the previously-selected group will be defeated.
However, if you have switched the cue signal group in a specific order when the CUE MODE
setting is MIX CUE, the state of the [CUE] keys for the previously-selected group will be restored
when the current cue signal is defeated.
The following illustration shows the
priority of the [CUE] keys. After you
have switched groups from lower to
upper levels, if you then defeat cue for
the upper group, the previous [CUE]
key status of the group immediately
below will be restored.
For example, if you switch groups in the
order of OUTPUT CUE group → DCA
CUE group → INPUT CUE group →
Other CUE group, you can then
successively defeat the [CUE] keys
(CUE/KEY IN CUE buttons) to successively restore the [CUE] key status of the previously-
selected group.
On-screen CUE button
Other CUE group
INPUT CUE group
DCA CUE group
OUTPUT CUE group

Operating the Cue function

This section explains how to use the [CUE] key for a channel or DCA group to monitor cue signals.
NOTE
Be aware that if you turn CUE INTERRUPTION off in the MONITOR popup window, the cue
signal will not be sent to the connected monitor speakers. However, the front panel PHONES jack
will always output the cue signal regardless of the Monitor on/off setting. See
function" on page 98 for details about the Monitor function.
1.
In the Function Access Area, press the MONITOR button to access the MONITOR
screen.
The CUE field on the MONITOR screen enables you to check the current cue settings, and turn
Cue on or off.
2
1
1
CUE popup display button
Enables you to access the CUE popup window, in which you can make detailed cue settings.
2
CUE MODE buttons
Select the cue mode. You can select MIX CUE mode (all selected channels will be cued), or LAST
CUE mode (only the channel selected most recently will be cued).
3
INPUT/DCA/OUTPUT CUE field
Indicates the settings for input cue, DCA cue, and output cue. Press this field to open the CUE
popup window.
102
Monitor and Cue functions
"Using the Monitor
3
4
5
Reference Manual