Recorder - Yamaha CL1 Reference Manual

3.
Use the CUE MODE button to select either the mode in which channels are mixed
for auditioning, or the mode in which only the last-selected channel is auditioned.
Select the MIX CUE button or LAST CUE button.
NOTE
In MIX CUE mode, it's not possible to simultaneously turn on Cue for different Cue groups. The
Cue group to which the last-cued signal belongs will be turned on, allowing only the signals of
that Cue group to be monitored.
4.
Use the buttons and knobs of the INPUT CUE field, DCA CUE field, and OUTPUT
CUE field to specify the output position and output level for each CUE group.
Refer to the explanation for each item in step 2, and make the desired settings.
5.
To specify a port as the output destination for cue signals L and R, press one of the
CUE OUTPUT buttons (L/R) in the meter field to open the PORT SELECT popup
window, and choose from the following cue signal output destinations (multiple
selections are allowed).
DANTE 1-64 Output channels 1–64 to audio network
OMNI1–8 OMNI OUT jacks 1–8
DIGI OUT L/R
DIGITAL OUT jack on the CL unit
SLOT1–1 – SLOT3–16 Output channels 1–16 of an I/O card installed in slots 1–3
When you have selected an output port, press the CLOSE button to close the popup window.
6.
To enable Cue out for the port you specified in step 5, press the CUE OUTPUT
button to turn it on.
NOTE
The cue signal is sent to the monitor output and PHONES output jacks regardless of whether the
CUE OUTPUT button is on or off.
However, be aware that the cue signal will no longer be sent to monitor output if CUE
INTERRUPTION is turned off. The cue signal is always sent to the PHONES output jack,
regardless of the CUE INTERRUPTION setting.
7.
Press the [CUE] key for a desired channel or DCA group to turn it on.
The cue signal of the corresponding channel will be sent to the output destination specified in step
5 and to monitor output.
A cue meter is shown in the meter field of the function access area, indicating the cue output level.
The upper part of the cue meter shows an abbreviation indicating the currently-enabled cue
group or cue type. The abbreviations displayed for the cue meters have the following meaning.
IN
INPUT CUE group
DCA DCA CUE group
OUT OUTPUT CUE group
EFFECT CUE in the EFFECT and PREMIUM RACK (Other CUE groups)
KEY IN KEY IN CUE in the DYNAMICS 1 popup window (Other CUE groups)
REC/PB CUE in the RECORDER INPUT/PLAYBACK OUT (Other CUE groups)
CUE meter
NOTE
• When using the MIX/MATRIX bus select buttons in the SENDS ON FADER popup window, you
can press the selected button once again to turn on Cue for the corresponding MIX/MATRIX
channel (see page 43).
• If you want cue operations and channel select operations to be linked, open the USER SETUP
popup window, choose the PREFERENCE tab, and then turn on "[CUE] → [SEL] LINK"
(see page 168).
104
Monitor and Cue functions
Reference Manual