User Defined Keys Setup - Yamaha CL1 Reference Manual

4.
Press the button corresponding to the USER DEFINED key to which you want to
assign a function.
The USER DEFINED KEY SETUP window will appear. In this window, you can select a function
to assign to the USER DEFINED key, and select the parameters.
NOTE
The list shown is the same for all models of the CL series.
For the CL3/CL1, the display will indicate "Cannot Assign!" if you specify a parameter that does
not exist on that model.
5.
Make sure that the FUNCTION field is enclosed by a frame, then use the
buttons in the lower part of the field or the multifunction knobs on the top panel
to select the function you want to assign.
For details on the assignable functions and their parameters, refer to
assigned to USER DEFINED keys" on
6.
If the selected function has parameters, press the PARAMETER 1 or 2 field to move
the frame, and select parameters 1 and 2 in the same way.
7.
Press the OK button to close the USER DEFINED KEY SETUP window.
8.
Assign the desired functions to other USER DEFINED keys in the same way.
9.
To execute an assigned function, press the corresponding USER DEFINED [1]–[16]
key on the panel.
"Functions that can be
page 259.
Using the Alternate function
If you assign the Alternate function (ALTERNATE FUNCTION) to a USER DEFINED key, you will be
able to switch parameters on or off by operating the knobs in the SELECTED CHANNEL section while
pressing and holding down the USER DEFINED key.
The console enters Alternate mode when you press and hold down the USER DEFINED key to which
the Alternate function has been assigned (the key will light).
The Alternate function features two options: LATCH and UNLATCH.
If you select UNLATCH, Alternate mode is turned on only while you are pressing and holding down
the USER DEFINED key. If you select LATCH, you will be able to turn Alternate mode on or off by the
key presses. You do not need to hold down the key.
NOTE
• The console exits Alternate mode when you switch the display between the OVERVIEW screen
and the SELECTED CHANNEL VIEW screen, or when you open a popup window.
• In Alternate mode, "ALT" will be displayed in the user name field of the Function Access Area.
In Alternate mode, the following knobs change their behavior.
• [GAIN] knob
Rotate the knob to adjust the digital gain value. If DIGITAL GAIN has been selected for HA
KNOB FUNCTION on the PREFERENCE page in the USER SETUP popup window, rotate this
knob to adjust the analog gain value of the head amp.
• [MIX/MATRIX] knob
Rotate this knob to switch between PRE and POST for the corresponding send signal.
Press this knob to switch the corresponding send signal on or off.
• [HPF] knob
/ Press this knob to switch the high pass filter on or off.
• [DYNAMICS 1] knob
Press this knob to switch DYNAMICS 1 on or off.
• [DYNAMICS 2] knob
Press this knob to switch DYNAMICS 2 on or off.
NOTE
In Alternate mode, all knobs in the SELECTED CHANNEL section other than those knobs
mentioned above will be disabled.
170
User settings (Security)
Reference Manual