Control Panel - Pfaff 3119 Instruction Manual

7

Control panel

.05
The keys on control panel 1 are used for selecting machine functions for setting-up pur-
poses, for sewing operations and for entering parameters.
Fig. 7 - 05
+
Plus / minus key
The values showed on the display can be increased or reduced on the respective key
-
using these keys.
Stop
When operated during a sewing cycle, the machine is stopped.
If operated outside a sewing cycle, the winding operation is started/stopped.
When entering the code number this key corresponds to the figure 0.
Step-by-step forwards / step-by-step backwards
Step-by-step movement through the entire sewing cycle forwards or backwards.
Basic position
In the operational mode Sewing the machine moves to the basic position.
In the operational mode Input the parameter input is interrupted (without the values being
saved) and the function group level of the parameter list is selected (100, 200, ..., 800).
Work clamp raised / lowered
In the operational mode Sewing the work clamp is raised/lowered.
When entering the code number, this key corresponds to number 6.
When moving step-by-step through the sewing cycle, all cutting procedures will
be carried out! Danger of injury if the knife engages!
Further functions can be selected with the keys described below, which are
each equipped with an LED. When the LED lights up the corresponding function
is activated / switched on.
Controls
1
7 - 3