Creating/Modifying Variable Programs (Only On Sub-Class -10/01) - Pfaff 3119 Instruction Manual

11 Creating/modifying variable programs (only on sub-class –10/01)
.05.03
On sub-class -10/01 there are 3 pre-set variable programs.
The variable program is written with the parameters of function group "300".
The variable program can be adapted to individual requirements by altering individual
parameters.
As illustrated below, variable programs consist of 2 part sections:
Seam A
Seam C
In addition to the purely geometrical data, a variable program is also defined by further
parameters:
Buttonhole model (32 to 34) see Chapter 11.05.04 Buttonhole models.
Number of stitches A and D
Secondary thread tension A and D
Seam A
Parameter settings for three variable programs for sewing hook-and-eye tapes for
underwear.
Parameter Description
301 Program number
302 Cut length (mm)
303 Buttonhole model
304 Distance of left seam to centre of cutting line (mm)
305 Width of left seam (mm)
306 Length of left seam (mm)
307 No. of stitches on left seam
308 Secondary thread tension of left seam
315 Secondary thread tension of 1
316 Distance of right seam to centre of cutting line (mm)
317 Width of right seam (mm)
318 Length of right seam (mm)
319 No. of stitches on right seam
320 Secondary thread tension of right seam
327 Secondary thread tension of 1
+ Distance A
Width A
st
bar
st
bar
Seam C
+ Distance C
Width C
Basic values
1
14.0
32
0.8
1.3
14.0
20
I
I
0.8
1.3
14.0
20
I
II
Input
2 3
41.0 53.0
32 32
0.8 0.8
1.3 1.3
41.0 53.0
48 64
I I
I I
0.8 0.8
1.3 1.3
41.0 53.0
48 64
I I
II II
11 - 7