Table of Contents
Advertisement
Controls
2
Control panel
.02
The control panel consists of display 1 and the function keys described below. The display
1 consists of a two-line alpha-numerical LCD display with 16 symbols per line. The texts 3
show the respective status of the function keys and the operating status of the machine.
The control panels switches on all LCD-segments and the horn automatically for a short time
during the power-on phase, after which the lettering PFAFF appears on the display, until the
higher-ranking control unit sends commands to the control panel.
2
Screen displays
.02.01
●
●
●
2
Function keys
.02.02
The function keys described below are used basically to switch machine functions on and
off.
If a corresponding value has to be set for the activated function, this is carried out with the
corresponding +/- key. By pressing and holding the corresponding +/- key, the appropriate
numerical value 4 is changed slowly to begin with. If the corresponding +/- key is held down
longer, the values change more quickly.
Start backtacks
●
6
3
1
Speed
4000
Activated functions are displayed with a triangular marking 2 below or next to the respec-
tive function key.
In the sewing mode all relevant sewing data is displayed and these can be changed di-
rectly, depending on the status of the machine, see also Chapter 5 Sewing.
During the parameter input the selected parameter number with the corresponding value
is displayed, see Chapter 2.02.03 Selecting/changing parameters.
If this key is pressed, the backtacks at the beginning of the seam (start backtacks) are
switched on or off. The number of forward stitches (A) or reverse stitches (B) for the start
backtacks can be changed by pressing the +/- key underneath. To convert from double
backtack to single backtack set the corresponding number of stitches at zero.
2
SRP
30%
4
Advertisement
Table of Contents
