Adjustment
13 - 37
1
2
5
56-070a
Fig. 13 - 32
Bring the needle to b.d.c.
Fit screw clamp 1 ( Part no. 61-111 600-35/001 ) to needle bar 2.
Bring 2.4 mm needle rise gauge ( Part no. 61-111 600-09 ) between the screw
clamp 1 and the guide stop of the needle bar 2.
Loosen the screw clamp 1, slide up as far as possible and tighten it again.
Remove the needle rise gauge.
Turn the balance wheel in the direction of sewing until screw clamp 1 has contact.
Twist or slide hook sleeve 3 (screws 4) in accordance with the requirement.
Loosen and remove screw clamp 1.
The machine remains switched on for the next adjustment.
6
3
4
5
6
0,1 mm
56-070b