13
Adjusting the cutting unit on sub-class -10/01
.47
13
Basic position of the knife bar and lower knife stop
.47.01
Requirement
When the knife cylinder is extended
1. Screw 2 should be positioned in the centre of the hole in the machine case and
2. The bottom edge of knife bar 5 should be positioned at a distance of 75 mm above the
bedplate.
1
Fig. 13 - 44
Press down guide unit 1 by hand (extend knife cylinder) until screw 2 is positioned in the
centre of the hole in the machine case.
Adjust stop screw 3 (screw 4) in accordance with requirement 1.
Adjust knife bar 5 (screw 2) in accordance with requirement 2.
56-060b
3
Adjustment
2
4
5
13 - 48