Using The Terminal; Battery & Display Information - Ingenico IWL220 Manual

Now switch on the mains supply.
1. Key in your merchant number and press the GREEN
button. The terminal will start to dial the Host computer
and a number of communication messages will be
displayed.
2. The terminal will now contact each card acquirer which
your terminal is configured to accept.
Further communications messages will be displayed. An
installation report will then be printed displaying the card
types that your terminal will accept.
3. Finally, the terminal will dial the Host computer to
report the successful installation.
4. Installation is now complete and the terminal will
display the READY prompt. Your terminal is now ready for
use.
6.

Using the Terminal

Switching the Terminal On and Off
To SWITCH ON the terminal when it is off the base, press:
If on the base the terminal will always be powered.
To SWITCH OFF the terminal, press (at the same time):
7. Battery & Display Information
Your terminal is supplied with a removable, rechargeable battery. This battery recharges when the
terminal is connected to the charger unit.
Following installation, the battery charge status is
indicated by the battery icon found in the top right hand
corner of the terminal display.
When you charge the battery for the first time, it should
be charged until full capacity is indicated. This may take
from 4 to 16 hours. New terminals are dispatched with
some charge present. Transactions can be performed
providing the terminal is connected to the charger unit so
that it can continue charging.
Page 8
Terminal Installation
Key in Merchant No.
and then press Enter
READY
Merchant Number
12345678
&
Battery low
Battery fully
charged (off
base)
4. The current time will be displayed. Re-key the correct
time and press the GREEN button.
The terminal will return to the READY prompt.
37. How to Set Sleep Parameters
This function allows you to set the time when the terminal is not in use before it goes into sleep
mode. Having the sleep parameters enabled will save on battery life.
1. At the READY prompt, press the MENU button twice.
Use the arrow buttons to view the available options and
press the GREEN button when the Select Function option
is highlighted.
2 Key enter the number 38 and press the GREEN button.
You will then be asked to swipe the Supervisor Card or
enter Supervisor code.
3. Press ENTER to continue setting Sleep Parameters or
Clear to cancel.
4. Enter the number of minutes before which the
terminal goes to sleep and then press the GREEN button.
The terminal will return to the READY prompt.
38. How to Print a Transaction Log
This function allows you to print a log of your last 100 transactions, should the need arise for
example to check any financial discrepancies.
At the READY prompt, press the MENU button twice.
Use the arrow buttons to view the available options and
press the GREEN button when the Select Function option
is highlighted.
2. Key enter the number 16 and press the GREEN button.
You will then be asked to swipe the Supervisor Card or
enter your Supervisor Code through the terminal.
3. To print a transaction log for the selected acquirer,
press the GREEN button. If not, press the YELLOW button.
SET DATE/TIME
Enter Current Time
dd/mm/yy
and then press ENTER
SYSTEM MENU
Totals
Print Function Codes
Select Function
Key in Function Code
and then press ENTER
SYSTEM
Sleep Parameters?
Enter=YES Clear=NO
Number of Mins before
going to sleep (1-30)
xx
and then press ENTER
SYSTEM MENU
Totals
Print Function Codes
Select Function
Key in Function Code
and then press ENTER
Print Transaction Log
<Aquirer Name>?
Enter=YES Clear=NO
Page 33