Ingenico IWL220 Manual page 6

1999/5/EC of 9 March 1999 on Radio and Telecommunications Terminal Equipment for:
• the protection of the health and the safety of the user and any other person.
• the protection requirements with respect to electromagnetic compatibility and complies with
harmonised standards.
Depending iWl220/250 model involved standards are:
EN 60950 1 :2006 According to 2006/95/EC
EN 55022 :2006 According to 2004/108/EC
EN 55024 A2 :2003 According to 2004/108/EC
EN 301489 1/7 /08 2005 According to 89/336/EEC
EN 301 511 /12 2003 According to 1999/5/EC
EN 62311 (2008) /07 2001 According to 1999/519/EEC
EN 301489 1/17 /08 2008 According to 89/336/EEC
EN 300 328 v1.4.2 /12 2000 According to 1999/5/EC
EN 301489 3 /08 2002 According to 89/336/EEC
EN 301357 1/2 (2008) According to 1999/5/EC
EN 50357;EN50364 /2001 According to 1999/519/EEC
And, for the whole range, complies with the European approval specification on connecting
terminals with DTMF dialling to the public switched telephone network (Council Decision 1998/482/
EC, Council Decision 1999/303/EC)
• TS 103021-1/2/3 /09-2003
• TR 103000-1/2/3/4 /06-2003
• ES 201187 /03-1999
WEEE Directive
The product belongs to the family of electrical and electronic equipment. Therefore it is subjected to
the WEEE Directive which requires the collection and recycling at the end of the life of the product.
Ingenico products present the symbol for the marking of electrical and electronic equipment as
required by the WEEE Directive.
The crossed through wheeled bin printed on the product gives information about the requirement
not to dispose of WEEE as unsorted municipal waste and to collect such WEEE separately.
To ensure that the product is collected and recycled with respect to the environment, you must con-
tact your supplier (contact the Ingenico local office or the commercial head office in charge of your
country on www.ingenico.com <<contact us>> page).
The abandonment or uncontrolled disposal of waste can harm the environment and human health.
So, by recycling your product in a responsible manner you contribute to the preservation of natural
resources and the protection of human health.
Batteries
If your product contains batteries they must be disposed of at the appropriate collection points.
Page 6
(Low Voltage Directive)
(EMC Directive)
(EMC Directive)
(EMC Directive)
(R&TTE Directive)
(R&TTE Directive)
(EMC Directive)
(R&TTE Directive)
(EMC Directive)
(R&TTE Directive)
(R&TTE Directive)
enter your Supervisor Code through the terminal.
4. To assign the terminal to a base unit press the GREEN
button.
To cancel the operation, press the YELLOW button.
5. Choose SELECT BASE and press the GREEN button.
6. Select the number of the base unit you wish to assign
your handset to and press the GREEN button.
You can now proceed to assign your handset to up to three more base units. Your terminal will
return to the READY prompt when each assignment is complete.
40. How to Change a Paper Roll
1. Hold the terminal securely in one hand. With the other
hand, and by using two fingers, lift the printer cover
release as shown. Fully open the printer cover and
remove the old roll of paper.
2. Unstick the end of the new roll, leaving the end free,
hold the paper roll as shown and carefully place into the
printer compartment.
3. Holding the free end of the paper and the terminal,
close the printer cover and push firmly until it locks.
Pressing the yellow CLEAR button will feed the paper
through.
SYSTEM
Radio Setup?
Enter=YES Clear=NO
RADIO SETUP
Assign to base
Select base
Remove base
SELECT BASE
40243643
40243582
Page 35