Standards - Ingenico IWL220 Manual

41. GSM Network
Please select option required from the Manual Mode Menu
and follow screen prompts.
42. Insuring the Terminal
Although you rent your terminal for a monthly charge it is strongly recommended that you insure
the terminal against loss or damage to a value as recommended by your acquirer.
43. Security Warning Notice
This terminal is used for the secure transfer of funds using credit and debit cards. As such it is
designed as a high security device.
Should you suspect that the terminal might have been removed, stolen or apparently modified or
replaced then you should advise your Bank immediately and stop using the terminal until advised
by the Bank accordingly. This is to protect both your business and also the persons who have or will
continue to use your terminal.
Please be vigilant at all times and check your terminal regularly.
44. Helpful Hints
Terminal Tips
Your terminal unit should be left in your retail premises and plugged into a 24 hour power supply at
all times.
If the terminal display is blank, ensure the terminal is plugged into the power supply.
If you have poor quality printing, change the paper roll.
Keep your Supervisor card in a secure place. Anyone with access to this card may perform
unauthorised refunds.
Financial Tips
Always check you have keyed in the correct amount before going ahead with the transaction.
If you are referred for an authorisation code, read the amount from the slip to ensure you have
the correct amount (It has been known for the amount of 2,000.00 to be keyed instead of 200.00.
A code is then obtained for the 200.00 but the cardholder is debited for the keyed amount of
2,000.00).
Always check your bank statement on a regular basis to ensure you are receiving your credits and
that the amounts are correct.
Remember to reconcile the terminal each day as this will generate all the funds to your bank
account.
You will not be credited with Z Totals as these are running totals for your records and do
not generate funds to your account.
Page 36
MANUAL MODE
Find Network
Select Network
Test Signal Strength
telephone connector from the telephone call socket, and place the telephone connector into the
telephone wall socket. You should hear a dial tone within 6 seconds.
Specific Absorption Rate (SAR) (GPRS ONLY)
The model wireless equipment meets the government's requirements for exposure to radio waves.
Your wireless equipment is a radio transmitter and receiver. It is designed and manufactured not to
exceed limits for exposure to radio frequency (RF) energy set by the Federal Communications
Commission (FCC) of the U.S. Government and by the Canadian regulatory authorities. These
limits are part of comprehensive guidelines and establish permitted levels of RF energy for the
general population. The guidelines are based on standards that were developed by independent
scientific organisations through periodic and thorough evaluation of scientific studies. The standards
include a substantial safety margin designed to assure the safety of all persons, regardless of age or
health.
The exposure standard for wireless equipment employs a unit of measurement known as the
Specific Absorption Rate, or SAR. The SAR limit set by the FCC and by the Canadian regulatory
authorities is 1.6 W/kg.
1. Tests for SAR are conducted using standard operating positions accepted by the FCC and by
Industry Canada with the phone transmitting at its highest certified power level in all tested
frequency bands. Although the SAR is determined at the highest certified power level, the actual
SAR level of the equipment while operating can be well below the maximum value. This is because
the equipment is designed to operate at multiple power levels so as to use only the power required
to reach th network. In general, the closer you are to a wireless base station, the lower the power
output.
Before a equipment model is available for sale to the public in the U.S. and Canada, it must be
tested and certified to the FCC and Industry Canada that it does not exceed the limit established by
each government for safe exposure. The tests are performed in positions and locations (e.g. at the
ear and worn on the body) reported to the FCC and available for review by Industry Canada. The
highest SAR value for this equipment when tested for use when worn on the body is 0.711 W/kg.
(Body worn measurements differ among phone models, depending upon available accessories and
regulatory requirements).
2. While there may be differences between the SAR levels of various terminal and at various
positions, they all meet the governmental requirements for safe exposure.
The SAR values found for the IWL220/250G GSM/GPRS Point of sale terminal are below the
maximum recommended levels of 1.6 W/Kg as averaged over any 1 g tissue according to the FCC
rule §2.1093, the ANSI/IEEE C 95.1:1999, the NCRP Report Number 86 for uncontrolled environment,
according to the Health Canada's Safety Code 6 and the Industry Canada Radio Standards
Specification RSS 102 for General Population/Uncontrolled exposure.
For body worn operation, this phone has been tested and meets FCC RF exposure guidelines when
used with an accessory that contains no metal and that position the device a minimum of 0 mm
from the body.
3.

Standards

CE Marking
The CE marking indicates iWL220/250 complies with the requirements of European Directive
Page 5