Palm Tungsten T3 Handbook page 173

Setting advanced outgoing mail options
You can set additional outgoing mail options.
To set advanced outgoing mail options:
(Optional) Select either of the following:
1.
The default is 25, the port number most SMTP servers use. If
Port Number
you are not sure about the correct port number, check with
your mail server administrator.
Select the My server requires authentication (ESMTP) check
Authentication
box if the outgoing server (SMTP) requires authentication.
Check with your system administrator before selecting this
option. See
chapter for information. If you select this option, username
and password fields appear. These fields are already filled in
based on the account information you entered previously. In
most cases, the information displayed is correct; however,
occasionally your authentication username and/or
password is different from your account username or
password. Check with your e-mail service provider for
authentication username and password information.
If you need to enter new information, enter a username
and/or tap the Password box and enter a password, and
then tap OK.
Tap Done.
2.
Testing your new account
After you finish setting up a new e-mail account, the Inbox of the account you just
created is displayed. You can test whether the e-mail account is set up and working
properly by tapping Get Mail. See
message" later in this chapter for more information.
If you set up a synchronize-only e-mail account, you need to configure this account
on your desktop. See
this chapter for information. You will not be able to synchronize e-mail between
your handheld and your desktop until you configure the account on your desktop.
"Adding ESMTP to an account"
Username and Password fields appear only if
ESMTP check box is selected
"Getting e-mail by subject or getting the entire
"Configuring account settings in HotSync Manager"
Setting up and managing e-mail accounts
later in this
later in
159