Konftel 300IP Manual page 51

Test Case #
Objective
Pre-Test Conditions
•
Local CUCMDUT(s):7100 & 7101; SCCP:1000; SIP:2000;
•
Remote CUCM DUT:8000; SIP:6201;
•
Configure CUCM Service Parameter: Device Mobility ModeOn
•
Mobile Voice Access service running on CUCM-PUB
•
Mobile Voice Access enabled on Voice Gateway
•
Remote Cluster Single Number Reach (SNR) configured for 6201 – Remote Device:444-7101
Add Remote Destination Profile:DeviceDevice SettingsRemote Destination ProfileAdd Newmobile1_rdp
Device SettingsSoftkey TemplateSIP_EP_UserAdd "Mobility" softkey (On-Hook & Connected)
User ManagementEnd Userrcuser21Check "Enable Mobility" &"Enable Mobile Voice Access"
DevicePhone6201Owner useridrcuser21
Remote Device: DevicePhone7101LineNo Answer Ring Duration60
•
RPC is used to remotely control IP Phones with DN: 1000,2000, 6201;
Test Procedure
1. 7100 dials 23462017101 answers
2. 7101 sends DTMF *74" after 30s
3. 6201 answers
4. 7101 goes on-hook
5. 6201 hits "Mobility" softkey after 30s
6. 7101 answers
7. 6201 goes on-hook
8. 7100 goes on-hook after 60s
9. Repeat steps 1-8 and replace the Calling DN:1000
10. Repeat steps 1-8 and replace the Calling DN:2000
11. Retrieve CDR from CUCM
12. Check the Calling, Called, Duration, Origination & Termination
Cause Codes
© 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
EP-43
Category
Verify DUT(s) supports Mobile Connect call to a remote SIP endpoint
Userid:rcuser21
o
Line:6201
o
Add New Remote Destination:
o
NameMobility_1
Destination Number 4447101
Check "Enable Unified Mobility", "Enable Single Number Reach" & "Enable Move to Mobile"
Test Results: Comments
At step 2 DUT also have to press on-hook.
Functional Test: Mobile Connect
Expected Results
•
Both 6201 & 7101 are ringing
•
Call establish between 7100 & 7101 with 2-way audio
•
Call is transferred to device 6201
•
Call establish between 7100 & 6201 with 2-way audio
•
2000 handoff call back to 7101
•
Call restored between 7100 & 7101
•
Final Call terminated normally
•
Results for SCCP and SIP call are similar as above
•
6 CDR(s) retrieved
•
Selected fields in CDR(s) match calls
RFC_Standard
P F N/A N/S N/T
x
Page 51 of 64
N
B