Konftel 300IP Manual page 44

Detailed end point ivt test plan and report
Hide thumbs Also See for 300IP:
Table of Contents

Advertisement

Test Case #
Objective
Pre-Test Conditions
Local CUCMDUT(s):7100 & 7101; SCCP:1000; SIP:2000;
Remote CUCM DUT:8000;
PSTN: 2102225400;
Enable DND on DN:7101
Service ParametersBLF Status Depicts DND True
DeviceDevice Settings > Softkey Template, add Do Not Disturb to a softkey template (Alerting and Connected state)
DevicePhoneDN:7101:
RPC is used to remotely control IP Phones with DN: 1000,2000, 2102225400;
Test Procedure
1. 7100 dials 71017100 goes on-hook after 5 secs
2. 8000 dials 444-71018000 goes on-hook after 5 secs
3. 1000 dials 71011000 goes on-hook after 5 secs
4. 2000 dials 71012000 goes on-hook after 5 secs
5. 2102225400 dials 941044471012102225400 goes on-hook
6. Retrieve CDR from CUCM
7. Check the Calling, Called, Duration, Origination & Termination
Cause Codes
© 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
EP-36
Category
Functional Test: Do Not Disturb (DND)
Verify "Do Not Disturb Ringer Off " feature is supported for DUT(s) endpoints
Do Not Disturbchecked
DND Option: Ringer Off
DND Incoming Call Alert: Flash Only
Test Results: Comments
Not supported on DUT
Expected Results
7101 flashes to indicate incoming call
Called party hears a ring back tone
7101 is given an option to answer call
Call terminated by Called party
5 CDR(s) retrieved
Selected fields in CDR(s) match calls
P
RFC_Standard
Y
F
N/A
N/S
N/T
B
x
Page 44 of 64

Advertisement

Table of Contents
loading

Table of Contents