Konftel 300IP Manual page 49

Test Case #
Objective
Pre-Test Conditions
•
Local CUCMDUT(s):7100 & 7101; SCCP:1000; SIP:2000;
•
Remote CUCM DUT:8000;
•
PSTN: 2102225400;
•
Configure CUCM Service Parameter: Device Mobility ModeOn
•
Mobile Voice Access service running on CUCM-PUB
•
Mobile Voice Access enabled on Voice Gateway
•
Local Cluster Single Number Reach (SNR) configured for 7101Remote Device:234-8000:
Add Remote Destination Profile:DeviceDevice SettingsRemote Destination ProfileAdd Newmobility_1_rdp
Device SettingsSoftkey TemplateSIP_EP_UserAdd "Mobility" softkey (On-Hook & Connected)
User ManagementEnd Userdutuser02Check "Enable Mobility" &"Enable Mobile Voice Access"
DevicePhone7101Owner useriddutuser02
Remote Device: DevicePhone8000LineNo Answer Ring Duration60
•
RPC is used to remotely control IP Phones with DN: 1000,2000, 2102225400;
Test Procedure
1. 7100 dials 71017101 answers7101 hits "Mobility" softkey after 30s
2. Select the option to send call to mobile device
3. 8000 answers
4. 7101 goes on-hook after 30s
5. 8000 sends DTMF *74 after 30s for call hanoff
6. 7101 answers
7. 8000 goes on-hook
8. 7101 goes on-hook after 30s
9. Repeat steps 1-7, replace 7100 with SCCP:1000
10. Repeat steps 1-7, replace 7100 with SIP:2000
11. Repeat steps 1-7, replace 7100 with PSTN:2102225400
12. Retrieve CDR from CUCM
13. Check the Calling, Called, Duration, Origination & Termination
Cause Codes
© 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
EP-41
Category
Verify DUT(s) supports Mobile Connect call to a remote DUT endpoint
Userid:dutuser02
o
Line:7101
o
Add New Remote Destination:
o
NameMobility_1
Destination Number 2348000
Check "Enable Unified Mobility", "Enable Single Number Reach" & "Enable Move to Mobile"
Test Results: Comments
Not supported on DUT
Functional Test: Mobile Connect
Expected Results
•
Both 7101(local) & 8000 (remote) are ringing
•
Call establish between 7100 & 7101 with 2-way audio
•
Call is transferred to mobile device 8000
•
Call establish between 7100 & 8000 with 2-way audio
•
8000 handoff call back to 7101
•
Call restored between 7100 & 7101
•
Final Call terminate normally
•
Results for SCCP, SIP & PSTN calls are similar as
above
•
6 CDR(s) retrieved
•
Selected fields in CDR(s) match calls
RFC_Standard
P F N/A N/S N/T
x
Page 49 of 64
N
B