Entrance Tests - Konftel 300IP Manual

Tests in this section requires RPC tool to remotely control Cisco IP Phones for manual calls. Follow
instructions highlighted in green in each test case before execution. It is important to restore
endpoints to it's original state in some test cases before proceeding to next test case.
Run "Step 3: Record_Functional_Test_Execution" command after executing all tests in this section
9.3

Entrance Tests

Tests will be focused on features and the operational behavior of the 3
corresponds to its design specifications
Test Case #
Objective
•
Local CUCM DUT(s):7100 & 7101; SCCP:1000; SIP:2000;
•
Configure Audio & Video Playback on an RDP Session for a PC accessing RPC Tool Server (Refer to Lab Guide for instructions)
 Launch RDPOptionsLocal Resources SettingsPlay on this computer

Access RPC Server via RDP
•
RPC is used to remotely control IP Phones :1000 & 2000;
1. 7100 dials 71017101 answers7100 on-hook after 30s
2. 7101 dials 1000Select 1000 and answer call using RPC
3. Select "Headphone" icon
4. Enter "Play:AreYouThere.raw" & hit "Send" on the Command Line
5. 7101 speaks "Testing1234"1000 on-hook after 60s
6 Repeat steps 2-5 with Calling DN:2000 & Called DN;7100
7. Repeat steps 2-5 with Calling DN:7101 & Called DN;2000
8. Calling & Called party release calls alternatively
9 Retrieve CDR from CUCM
10. Check Calling, Called, Duration, Origination & Termination
Cause Codes
CDR field
callingPartyNumber
OriginalCalledPartyNumber
finalCalledPartyNumber
origCause_Value
destCause_Value
duration
Note:
• In RPC Tool, if any of the Phones used in test case is in un-registered state, use any available registered IP Phones.
Phone displays without a DN assigned are un-registered.
• Refer to Lab Guide for instructions on:
CDR Retrieval from CUCM
Phoneview User Guide
2-Way Audio Path Validation
© 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Retrieve CDR(s) in CUCM to validate calls
.
EP-2
Category Entrance Test: Intra-Cluster Calls
Verify intra-cluster calls between DUT, SCCP and SIP endpoints
Test Procedure
Test Results: Comments
Pre-Test Conditions
Expected Results
•
4 calls establish with 2-way audio path
•
Calling and Called Parties hear ring-back and ring tone
•
DUT receives Caller ID
•
Phone on RPC displays "monitoring active" message with
symbol
•
7100 & 7101 hear "Are you There"
•
1000 & 2000 hear "Testing 1234"
•
Audio for RPC phones heard on pc running Phoneview
•
4 calls terminate normally
•
4 CDR(s) retrieved
•
Selected fields in CDR(s) match table
Call 1
7100
7101
7101
16
0
30
rd
party product (DUT) to ensure it
RFC_Standard
Call 2 Call 4
7101 7101
1000 2000
1000 2000
0 16
16 0
60 60
P F N/A N/S
X
Page 15 of 64
Y
Call 5
2000
7100
7100
0
16
60
N/T B