Konftel 300IP Manual page 45

Test Case #
Objective
Pre-Test Conditions
•
Local CUCMDUT(s):7100 & 7101; SCCP:1000; SIP:2000;
•
Remote CUCM DUT:8000;
•
PSTN: 2102225400;
•
Enable DND on:7100

DevicePhoneDN:7100update BLF Status Depicts DNDTrue

DeviceDevice Settings > Softkey Template, add Do Not Disturb to a softkey template *Alerting and Connected state

DevicePhoneDN:7101:
•
RPC is used to remotely control IP Phones with DN: 1000, 1001, 2000, 2102225400;
Test Procedure
1. 1001 dials 71007100 answers
2. 7101 dials 71007100 hits "DND" softkey in connected state
3. 7101 goes on-hook
4. 8000 dials 444-71007100 hits "DND" in connected state
5. 8000 goes on-hook
6. 1000 dials 71007100 hits "DND" softkey in connected state
7. 1000 goes on-hook
8. 2000 dials 71007100 hits "DND" softkey in connected state
9. 2000 goes on-hook
10. 2102225400 dials 71007100 hits "DND" in connected state
11. 1001 goes on-hook after 200s
12. Retrieve CDR from CUCM
13. Check the Calling, Called, Duration, Origination & Termination
Cause Codes
© 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
EP-37
Category Functional Test: Do Not Disturb (DND)
Verify "Do Not Disturb Call Reject " feature is supported on DUT(s) endpoints
Do Not Disturbchecked
DND Option: Call Reject
DND Incoming Call Alert: Beep Only
Test Results: Comments
Not supported on DUT
Expected Results
•
Call establish between 1001 & 7100 with 2-way audio
•
7100 hears ringback for all incoming calls in connected state
•
CUCM rejects call with Reason:User Busy
•
7100 hears a beep for all the rejected calls
•
5 calls terminate with User_Busy
•
st
1 call terminate normally
•
6 CDR(s) retrieved
•
Selected fields in CDR(s) match calls
P
RFC_Standard N
F N/A N/S N/T B
x
Page 45 of 64