Konftel 300IP Manual page 39

Test Case #
Objective
Pre-Test Conditions
•
Local CUCMDUT(s):7100 & 7101; SCCP:1000; SIP:2000;
•
Remote CUCM DUT:8000; SCCP DN:5200; SIP DN:6200;
•
PSTN: 210-222-5400;
•
Hunt Group Pilot 3015 (1
# of callers in queue=1;
•
RPC is used to remotely control IP Phones with DN: 1000, 2000, 2102225400;
Test Procedure
1. 7100 dials 30152000 answers
2. 7101 dials 3015
3. 8000 dials 444-3015
4. 7100 goes on-hook after 200 secs
5. Retrieve CDR from CUCM
6. Check the Calling, Called, Duration, Origination & Termination
Cause Codes
© 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
EP-31
Category Functional Test: Hunt Group
Verify "Hunt Group" calls on DUT(s) when maximum queue length exceeded
st
member-2000), Queuing flag enabled, max. waiting timer=60 secs, Route call to Destination disabled; Max.
Test Results: Comments
Expected Results
•
Call route to hunt group member 2000
•
Call establish between 7100 & 2000 with 2-way audio
•
7101 & 8000 waiting in queue
•
Maximum number of callers in queue exceeded
•
Maximum wait timer exceeded 60s
•
Both calls (8000 & 7101) were not terminated to hunt group
•
3 CDR(s) retrieved
•
Selected fields in CDR(s) match calls
P
x
RFC_Standard N
F N/A N/S N/T B
Page 39 of 64