Konftel 300IP Manual page 46

Test Case #
Objective
Pre-Test Conditions
•
Local CUCMDUT(s):7100 & 7101; SCCP:1000; SIP:2000;
•
Remote CUCM DUT:8000;
•
PSTN: 2102225400;
•
VM enabled on all phones; VM Pilot # 7000; DevicePhoneDNLineVoicemailDefault
•
Enable iDivert on DN:7101

Service ParameterLegacy Immediate DivertTrue

DeviceDevice Settings Softkey TemplateSIP_EP_User (Add iDivert to template - Connected, On Hold & Ring states)

DevicePhoneDN:7101Softkey TemplateSIP_EP_User
•
RPC is used to remotely control IP Phones with DN: 1000,2000, 2102225400;
Test Procedure
1. 7100 dials 71017101 hits "iDivert" softkey during ringing state
2..7100 leaves a voicemail and goes on-hook
3. 8000 dials 444-71017101 hits "iDivert" softkey in ringing state
4. 8000 goes on-hook without leaving a message
5. 1000 dials 71017101 hits "iDivert" softkey during ringing state
6. 1000 leaves a voicemail and goes on-hook
7. 2000 dials 71017101 hits "iDivert" softkey during ringing state
8. 2000 leaves a voicemail and goes on-hook
9. 2102225400 dials 94104447101
10. 7101 hits "iDivert" softkey during ringing state
11. 2102225400 leaves a voicemail and goes on-hook
12. Retrieve CDR from CUCM
13. Check the Calling, Called, Duration, Origination & Termination
Cause Codes
© 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
EP-38
Category
Functional Test: iDivert
Verify "IDivert " call between DUT(s), SCCP, SIP and PSTN endpoints
Test Results: Comments
Not supported on DUT
Expected Results
•
7100 directed to 7101's voicemail box
•
8000 directed to 701's voicemail box
•
1000 directed to 7101's voicemail box
•
2000 directed to 7101's voicemail box
•
2102225400 directed to 7101's voicemail box
•
MWI "On" when voicemail present for 7101
•
7101 able to retrieve all 4 voicemails
• th
MWI "Off" only after 4 voicemail was retrieved
•
All calls terminate normally
•
5 CDR(s) retrieved
•
Selected fields in CDR(s) match calls
P
RFC_Standard
N
F N/A N/S N/T B
x
Page 46 of 64